Safety Decals - Ferris IS600 Series Operator's Manual

4) Mounting hardware that is of a grade lesser than
specified.
5) Machine GVW (Gross Vehicle Weight), including
attachments, restrained payload, fuel and operator, in
excess of the maximum weight specified on the ROLL
BAR label.
6) Any modifications that have been made, such as
unauthorized welds and holes.
7) Any permanent deformation or twisting of the ROLL
BAR structure.
8) That the ROLL BAR label is still in place and is
readable.
9) That the ROLL BAR on-product warning labels are still
on the ROLL BAR and are readable.
• If there is any doubt as to the condition of the ROLL BAR,
remove the machine from service and contact your dealer
for assistance.
Inspection and Maintenance of the Roll Bar
Seat Belt
WARNING
Failure to properly inspect and maintain the seat belt can
cause serious injury or death.
4
• The seat belt like the ROLL BAR, needs to be
periodically inspected to verify that the integrity has not
been compromised through normal machine use, misuse,
age degradation, modifications, or a roll over. If the seat
belt does not pass all of the following tests, it should be
replaced.
• BEFORE EACH USE – Conduct the following
inspections/maintenance of the seat belt and retraction
mechanism:
1) Check for dirt or debris in the retraction mechanism. If
dirt or debris is found, it should be removed.
2) Check to make sure the retraction mechanism retracts
easily and completely.
3) Check for damage to any part of the seat belt (A,
Figure 4) such as nicks, cuts, loose stitching, or fraying.
4) Check that the buckle and latch (B) operate properly
and that the latch plate is not excessively worn,
deformed, or the buckle is damaged or cracked. The seat
belt should latch and release easily.

Safety Decals

Read the safety decals before operating your unit. The
cautions and warnings are for your safety. Understand and
follow all safety decals to avoid a personal injury or damage
to the unit.
WARNING
If any safety decals become worn or damaged and
cannot be read, order replacement decals from your
local dealer.
5
* Located on the pump plate at the rear of the unit.
** Decals are located at the Roll Bar mounting point on the unit.
A. Part Number: 5109104 - Decal, Main Safety
B. Part Number: 7101665 - Decal, Danger, Discharge
C. Part Number: 5061245 - Decal, Warning, Pinch Point
D. Part Number: 5103184 - Decal, Warning, Hand in Belt
E. Part Number: 5104082 - Decal, Warning, Folding Roll
Bar
F. Part Number: 5104083 - Decal, Caution, Folding Roll
Bar
G. Part Number: 5100405 - Decal, Warning, Overhead
Obstacles
H. Part Number: 5100685 - Decal, Warning, Roll Bar
Removed
Fuel Cap Fuel Recommendation
I.
11