Safety Decals - Ferris IS5100Z Series Operator's Manual

4) Mounting hardware that is of a grade lesser than
specified.
5) Machine GVW (Gross Vehicle Weight), including
attachments, restrained payload, fuel and operator, in
excess of the maximum weight specified on the ROLL BAR
label.
6) Any modifications that have been made, such as
unauthorized welds and holes.
7) Any permanent deformation or twisting of the ROLL BAR
structure.
8) That the ROLL BAR label is still in place and is readable.
9) That the ROLL BAR on-product warning labels are still
on the ROLL BAR and are readable.
• If there is any doubt as to the condition of the ROLL BAR,
remove the machine from service and contact your dealer
for assistance.
Inspection and Maintenance of the Roll Bar Seat
Belt
WARNING
Failure to properly inspect and maintain the seat belt can
cause serious injury or death.
3
• The seat belt like the ROLL BAR, needs to be periodically
inspected to verify that the integrity has not been
compromised through normal machine use, misuse, age
degradation, modifications, or a roll over. If the seat belt
does not pass all of the following tests, it should be replaced.
• BEFORE EACH USE – Conduct the following
inspections/maintenance of the seat belt and retraction
mechanism:
1) Check for dirt or debris in the retraction mechanism. If
dirt or debris is found, it should be removed.
2) Check to make sure the retraction mechanism retracts
easily and completely.
3) Check for damage to any part of the seat belt (A, Figure
3) such as nicks, cuts, loose stitching, or fraying.
4) Check that the buckle and latch (B) operate properly and
that the latch plate is not excessively worn, deformed, or
the buckle is damaged or cracked. The seat belt should
latch and release easily.

Safety Decals

Before operating your unit, read the safety decals. The cautions
and warnings are for your safety. To avoid a personal injury or
damage to the unit, understand and follow all safety decals.
WARNING
If any safety decals become worn or damaged, and cannot
be read, order replacement decals from your local dealer.
*Decal is located on the battery.
**Decal is located on pump plate.
***Decal is located behind the Roll Bar on the frame of the unit.
A Part No.: 5102627 - Decal, Main Safety, ANSI CE
B Part No.: 5061246 - Decal, Pinch Point, CE
C Part No.: 5102456 - Decal, Fire ANSI Export
11