Table of Contents
Advertisement
Section 3: Adjustments
Side Plate Positioning
Side plates are utilized to gather and keep rocks and
debris in front of the roller for the purpose of distributing
material over low areas.
Working Position
Refer to Figure 3-5:
The side plates are attached on the front side to
mounting tabs and pins for gathering and distributing
material while traveling forward.
1. Remove linchpin (#5) and install right-hand side
plate (#3) over front mounting tabs (#4) and side
plate guide (#2) over front mounting pin (#1).
2. Secure side plate (#3) with linchpin (#5).
3. Repeat steps 1 thru 2 for left-hand side plate.
Working Position of Side Plates (Right-Hand Side Shown)
Figure 3-5
18
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M
Table of Contents
Storage Position
The side plates can be removed and mounted on the
back side at opposite ends for storage. This is often done
to complete final grading.
Refer to Figure 3-6:
Store left-hand side plate on the right-hand side of the
rake as follows:
1. Remove linchpin (#5) and install left-hand side
plate (#3) over rear mounting tabs (#4) and side plate
guide (#2) over rear mounting pin (#1).
2. Secure side plate (#3) with linchpin (#5).
3. Repeat steps 1 thru 2 to store right-hand side plate
on the left-hand side.
24535
Storage Position of Side Plates (Right-Hand Side Shown)
Figure 3-6
24536
21106
6/11/14
Advertisement
Table of Contents
