Table of Contents
Advertisement
Section 4: Maintenance & Lubrication
Remove Skid Shoe
To Grease
22
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M
Table of Contents
Chaincase
Fill Plug
IMPORTANT: Check oil level after the machine has
been operating long enough to cause oil to become
hot and fluid. Level machine and remove lower level
plug. Oil should reach bottom of level plug hole. If
needed, add recommended lubricant through the
level hole or fill hole. Tighten all removed plugs.
Lower Plug
Type of Lubrication:
Shell Gadus S2 V220 00 flowable grease or equivalent
Land Pride #821-086C (14 oz [0.41 L] cartridge)
Quantity when empty: 22 oz (0,65 L)
Quantity when low: Oil should reach bottom of level
plug hole when in the liquid state.
30937
Pivot Arm Bushings (8 Places)
Grease pivot arm bushings every 25 hours
Two grease zerks for each pivot arm
Type of Lubrication: Multi-Purpose Grease
Quantity: Add grease until grease begin to emerge from
either side of the bushings.
30665
Non-Drive Bearing
Grease gauge non-drive bearing every 10 hours
One grease zerk inside skid shoe
Type of Lubrication: Multi-Purpose Grease
(Remove Skid Shoe to grease)
Quantity: Add grease until grease begin to emerge from
either side of the axle.
24533
As
Required
25
Hours
25
Hours
6/11/14
Advertisement
Table of Contents
