Table of Contents
Advertisement
Important Safety Information
These are common practices that may or may not be applicable to the products described in
this manual.
Shutdown and Storage
Before leaving operator's
seat:
Lower lift arms and put
attachment flat on the ground.
Turn off engine and engage
parking brake.
If included, raise seat bar and
move controls until both lock.
Remove key to prevent
unauthorized starting.
Use steps, grab-handles and
skid-resistant surfaces when
getting on or off the loader.
Detach and store implements in
an area where children normally
do not play. Secure implement by
using blocks and supports.
OFF
Use Safety
Lights and Devices
Slow moving self-propelled
equipment, and towed implements
can create a hazard when driven
on public roads. They are difficult
to see, especially at night.
Flashing warning lights and turn
signals are recommended
whenever driving on public roads.
2
SR2672 & SR2690 Skid Steer Powered Rakes 321-004M
Table of Contents
Transport Safely
Comply with state and local laws.
Never travel at a speed which does
not allow adequate control of
steering and stopping. Some rough
terrains require a slower speed.
Avoid contact with any over head
utility lines or electrically charged
conductors.
Always drive with load on end of
loader arms low to the ground.
Always drive straight up and down
ramps with load on "uphill" side of
skid steer.
Engage parking brake when
stopped on an incline.
Practice Safe Maintenance
Understand procedure before doing
work. Use proper tools and
equipment, refer to Operator's
Manual for additional information.
Work in a clean dry area.
Lower attached implement to the
ground and follow all shutdown
procedures before leaving the
operator's seat to perform
maintenance.
Allow implement to cool completely.
IMPORTANT: Do not tow a load
that is more than double the weight
of the vehicle towing the load.
Use towing vehicle and trailer of
adequate size and capacity. Secure
equipment towed on a trailer with
tie downs and chains.
Sudden braking can cause a towed
trailer to swerve and upset. Reduce
speed if towed trailer is not
equipped with brakes.
Disconnect battery ground cable (-)
before servicing or adjusting
electrical systems or before
welding on implement.
Do not grease or oil implement
while it is in operation.
Inspect all parts. Make sure parts
are in good condition & installed
properly.
Remove buildup of grease, oil, or
debris.
Remove all tools and unused parts
from implement before operation.
6/11/14
Advertisement
Table of Contents
