Rinnai P Series Installation Manual page 8

WARNINGS AND IMPORTANT INFORMATION
CLEANING AND MAINTENANCE WARNINGS
Turn off the device and disconnect the power before cleaning. Failure to do so can cause electrical
WARNING
shock.
DO NOT clean the air conditioner with excessive amounts of water.
DO NOT clean the air conditioner with combustible cleaning agents. Combustible cleaning
agents can cause fire or deformation.
OPERATING CAUTIONS
Turn off the air conditioner and disconnect the power if you are not going to use it for a long time.
CAUTION
Turn off and unplug the unit during storms.
Make sure that water condensation can drain unhindered from the unit.
DO NOT operate the air conditioner with wet hands. This may cause electric shock.
DO NOT use device for any other purpose than its intended use.
DO NOT climb onto or place objects on top of the outdoor unit.
DO NOT allow the air conditioner to operate for long periods of time with doors or windows
open, or if the humidity is very high.
ELECTRICAL WARNINGS
Only use the specified power cord. If the power cord is damaged, it must be replaced by the
WARNING
manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Keep power plug clean. Remove any dust or grime that accumulates on or around the plug. Dirty
plugs can cause fire or electric shock.
DO NOT pull power cord to unplug unit. Hold the plug firmly and pull it from the outlet. Pulling
directly on the cord can damage it, which can lead to fire or electric shock.
DO NOT modify the length of the power supply cord or use an extension cord to power the unit.
DO NOT share the electrical outlet with other appliances. Improper or insufficient power supply
can cause fire or electrical shock.
The product must be properly grounded at the time of installation, or electrical shock may occur.
For all electrical work, follow all local and national wiring standards, regulations, and the
Installation Manual. Connect cables tightly, and clamp them securely to prevent external forces
from damaging the terminal. Improper electrical connections can overheat and cause fire, and
may also cause shock. All electrical connections must be made according to the Electrical
Connection
Diagram located on the panels of the indoor and outdoor units.
All wiring must be properly arranged to ensure that the control board cover can close properly. If
the control board cover is not closed properly, it can lead to corrosion and cause the connection
points on the terminal to heat up, catch fire, or cause electrical shock.
If connecting power to fixed wiring, an all-pole disconnection device which has at least 3mm
clearances in all poles, and have a leakage current that may exceed 10mA, the residual current
device (RCD) having a rated residual operating current not exceeding 30mA, and disconnection
must be incorporated in the fixed wiring in accordance with the wiring rules.
Rinnai 8 Split AC IM