Removing Control Panel Assembly - Singer Futura CE-150 Service Manual

Removing control panel assembly

Note! The rear and front covers need not to be removed.
The Circuit board of control panel assy. is mounted on the front cover under the control panel with two
screws
1. Remove support leg and base cover.
A
2. Lay the machine on its back and remove two screws (A) by tuning
them through the hole of bracket.
3. Push up the control panel from the bottom of machine.
4. Pull out the control panel from the front cover.
Disconnect the 4 cables (B) from the control panel.
Then remove the control panel.
B
Note: When adjusting the machine with the front cover removed, connect the control panel assy. with the
machine.
Singer Furtura III series 37