6. Insert 2.5" x 10" cardboard between the Brake Magnet (C) and the
Flywheel (B), and tape the cardboard to the Brake Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
B
C
B
G
7. Observe the cable routing to the wiring harness (D) on your machine.
Disconnect the Speed Sensor Cable (E) and Power Inlet Cable (F) from
H
the wiring harness.
D
E
F
8. Tie the length of string to the end of the lower Console Cable (G) at
the top of the Mast mount. Pull the cable and string down through the hole
(H) on the side of the Frame so that the string extends through the Frame.
Remove the zipties that attach the lower Console Cable to the Frame.
9. Untie the string from the Console Cable (G).
G
86