Schwinn 130/510U Service Manual page 22

10. To adjust the Brake tension, loosen the 2 hex head bolts (E) and
move the Servo Motor assembly (D) until the closest point on the Brake
Magnet (C) is within 3.0 mm (1/8") of the Flywheel (B). Tighten the bolts.
Note: If the cardboard is not 3mm (1/8") thick, you can use
the pages of a paperback book to measure the gap.
Approximately 36 pages (sheets) = 3mm.
11. Turn the power on again. Use the console to check the resistance
adjustment.
Machine is on. Current is active. There is risk of electrical
shock.
Note: Before fully attaching the Shrouds, remove the cardboard from
between the Brake Magnet (A) and the Flywheel (B). Power
up the machine to verify that the Magnet Arm can move freely,
and that the Brake Magnet and Flywheel do not touch.
12. Installation is the reverse procedure. Put the Left Shroud in position
first to align the screws for the Right Shroud. Install the top screws first.
Note: Self-tapping screws attach the Shrouds to the Frame.
NOTICE: Be sure not to pinch or cut any cables. Be sure the tabs in
the Top Shroud snap into the Main Assembly.
13. Attach the Pedals. Start the Pedals by hand, and then fully tighten
them with the Pedal Wrench. The Pedals must be fully tightened.
If the threads strip due to improper installation, then the
Pedals can disengage from the bike and/or break while under
usage, which can result in serious injury to the user.
Note: The Left Pedal is reverse-threaded. Be sure to attach
Pedals on the correct side of the Bike. Orientation is based
from a seated position on the bike. The Left Pedal has an "L",
the Right Pedal an "R".
D
(R)
22
C
E
B
(L)