Table of Contents
Advertisement
1. Engine Settings
2. Set Low Mow Speed
3. Engine speed in rpm (e.g.,
3,600 rpm)
The system does not allow the following to occur:
•
The efficient speed cannot be set higher than the
maximum speed.
•
The low speed cannot be set higher than the
efficient speed.
Note:
You can set the maximum speed equal to the
efficient mow speed to use the efficient mode while
mowing.
You can enable mowing in high ground speed
55).
1. Engine settings
2. High speed PTO
3. Enabled
Figure 54
4. Up arrow—Increase
5. Enter
6. Down arrow—Decrease
Figure 55
4. Enable
5. Disable
Adjust the Fan Settings
These screens are used to adjust how often the fan
reverses
(Figure
g030228
1. Fan settings
To change the fan reversal time interval, press the
down arrow to decrease the minutes or pressing the
up arrow to increase the minutes (5 to 60 minutes).
After completing the change, press enter
(Figure
1. Fan settings
2. Set the fan reversal time
interval
This screen allows you to monitor the outputs and
initiate a manual reversal.
g320843
Note:
The delay is converted to seconds as shown
in
Figure
58.
1. Fan settings
2. Start fan reversal
3. 000% fan speed command
19
56).
Figure 56
2. Adjust fan settings
Figure 57
3. 20 minutes (current fan
reversal interval)
Figure 58
4. 000s fan reverse delay
5. Reverse (initiate fan
reversal cycle)
g320727
(Figure
57).
g320728
g320729
Advertisement
Table of Contents
