Toro 72144 Software Manual page 11

The following are a list of items available in the Status
of Inputs screen:
•
System voltage
•
Engine communication (highlights if the module is
communicating with the engine ECU)
•
PTO switch (highlights if on)
•
Neutral switch (highlights if on)
•
Brake switch (highlights if on)
•
Seat switch (highlights if on)
•
Oil-pressure switch (highlights if on)
•
Engine temperature (shows temperature)
•
Transmission temperature (shows temperature)
•
Fuel-rail pressure (shows pressure, if applicable)
•
Diesel-Oxidation Catalyst (DOC) inlet and outlet
temperature (shows temperature, if applicable)
•
Air-filter switch (highlight if on)
•
Wing Deck (highlights if the wing decks are
down/ready to mow)
•
Transmission speed
•
Fan voltage
Status of Outputs
This screen lists all of the outputs from the system
and highlights which one is currently active. Outputs
with numerical values display the current value.
You can toggle through all the outputs by pushing the
pushing the button.
1. Status of outputs
2. Speed signal
The following are a list of items available in the Status
of Outputs screen:
•
PTO output (highlights if on)
•
Engine shutdown output (highlights if on)
•
Module communication (highlights if LDU and
MCU are communicating)
•
Alarm (highlights if on)
•
Starter (highlights if on)
Figure 23
3. Clutch output
4. Engine power to run
•
Fuel pump power (highlights if on)
•
Engine power to run (highlights if on)
•
Fan speed percentage
•
Fan reverse delay
Current Error Messages
This screen displays the current error as text with the
engine hours at which the error occurred. The toggle
button allows you to scroll between screens if multiple
errors are active. If only 1 error occurs, the toggle
button does not change screens.
1. Current Error
2. Error display (e.g., Low Oil Pressure)
3. Engine hours when the error occurred
g038556
11
Figure 24
g030185