Table of Contents
Advertisement
CARE AND MAINTENANCE
CARE AND MAINTENANCE
CAUTION
• Be sure to unplug the machine before cleaning
it. Otherwise, injury may result.
Restrictions on Oiling
In order to prevent damaging this machine, it must
not be oiled by the user. This machine was
manufactured with the necessary amount of oil
applied to ensure correct operation, making
periodic oiling unnecessary.
If problems occur, such as difficulty turning the
handwheel or an unusual noise, immediately stop
using the machine, and contact your authorized
Brother dealer or the nearest Brother authorized
service center.
Precautions on Storing the
Machine
Do not store the machine in any of the locations
described below, otherwise damage to the
machine may result, for example, rust caused by
condensation.
*
Exposed to extremely high temperatures
*
Exposed to extremely low temperatures
*
Exposed to extreme temperature changes
*
Exposed to high humidity or steam
*
Near a flame, heater or air conditioner
*
Outdoors or exposed to direct sunlight
*
Exposed to extremely dusty or oily environments
Note
• In order to extend the life of this machine,
periodically turn it on and use it. Storing this
machine for an extended period of time
without using it may reduce its efficiency.
Cleaning the LCD Screen
If the surface of the LCD is dirty, lightly wipe it
with a soft dry cloth.
Memo
• Occasionally, condensation may form on the
LCD screen or it may become fogged up;
however, this is not a malfunction. After a
while, the cloudiness will disappear.
178
Cleaning the Machine Casing
When wiping dirt off the machine, firmly wring a
soft cloth soaked in (lukewarm) water.
After cleaning the machine, dry it with a soft, dry
cloth.
Cleaning the Race
a
Press the "Needle Position" button to raise
the needle.
b
Turn the main power to OFF, and then
unplug the machine.
c
Remove the needle and the presser foot.
(page 54, page 57)
d
Remove the flat bed attachment or the
embroidery unit if either is attached.
e
Slide the needle plate lever toward you.
a Slide toward you.
The needle plate opens.
f
Slide out the needle plate with your right
hand to remove it.
g
Grasp the bobbin case, and then gently lift
out.
a
a Bobbin case
a
Advertisement
Table of Contents
