Changing The Start And End Angles Of The Stitch Pattern; Tapering Function) - Brother 882-W33 Operation Manual

SEWING THE STITCHES
Changing the Start and End
Angles of the Stitch Pattern
(Stitch Tapering Function)
The angles of the start and end of stitch patterns
can be changed. This is useful when sewing
projects with sharply defined angles or decorative
stitching, attaching appliqués, etc.
Use the method for finishing sewing the stitch
pattern, according to your needs.
• Method 1: Begin Changing the Angle at the End
of Sewing by Pressing the "Reverse Stitch" Button
(page 142)
• Method 2: Sewing a Specified Number of Stitch
Patterns (page 143)
• Method 3: Specifying the Sewing End Point with
an End Point Sticker (page 144)
Note
• Using the same material and stitch pattern as
your project, sew trial stitches to check the
result. If necessary, attach a stabilizer
material.
• If reinforcement stitches at the beginning and
end of sewing are needed, use "Reinforcement
Stitch" button. "Reverse Stitch" button cannot
be used for reinforcement stitching when stitch
tapering function is on.
■ Method 1: Begin Changing the Angle
at the End of Sewing by Pressing the
"Reverse Stitch" Button
a
Touch
stitch pattern for stitch tapering.
142
, then , and then select a
b
If necessary, change the stitch width and
stitch length.
c
Touch , and then touch
d
Touch , select the angle settings for
the start and end of sewing, and then touch
.
a Select the start or end of sewing.
b Select an angle.
c Specify that the angle does not change.
.
a
b
c