Using The Spool Stand - Brother 882-W33 Operation Manual

UPPER THREADING
l
Start sewing.
Memo
• To change direction when sewing with the
twin needle, raise the needle from the fabric,
raise the presser foot lever, and then turn the
fabric.

Using the Spool Stand

1 2
4 5
No.
1 Spool stand
2 Spool cap (XL) × 2
3 Spool holder × 2
4 Spool cap base × 2
5 Spool felt × 2
6 Ring × 4
* No.2 to No.6 are included in a plastic bag.
Memo
• Refer to page 16 to assemble the spool stand.
• Refer to page 44 to wind the bobbin when
using the spool stand.
■ About the Thread Spool and Spool
Cap
• Be sure to use a spool cap that is slightly larger
than the spool.
If the spool cap that is used is smaller or much
larger than the spool, the thread may catch and
sewing performance may suffer.
52
3
6
Part Name
• When using thread on a thin spool, place the
included spool felt on the spool pin, place the
thread spool on the spool pin so that the center
of the spool is aligned with the hole at the center
of the spool felt, and then insert the spool cap
onto the spool pin.
a Spool felt
• When using thread on a cone spool, use the
spool holder. When using cone shaped thread
spool with other than cotton thread, it is not
necessary to use spool caps.
a Spool holder
• Depending on the size of spool or the amount of
thread remaining, choose the appropriate sized
spool cap (large or medium). Spool cap (small)
cannot be used with the spool cap base.
a
a Spool cap
b Spool cap base