Table of Contents
Advertisement
SEWING THE STITCHES
■ Method 3: Specifying the Sewing End
Point with an End Point Sticker
Note
• For details on the procedure as well as
precautions, refer to "Specifying the Sewing
End Point" on page 86.
a
With a chalk pencil, mark the fabric with
lines for sewing the stitch pattern and for
the end of stitching.
b
Affix an end point sticker, avoiding the
sewing area. Attach the end point sticker
within 4 cm (approx. 1-1/2 inches) to the
left or right of the chalkline where the end
point for sewing has been drawn.
a 4 cm (Approx. 1-1/2 inches)
Memo
• If you cannot affix an end point sticker
avoiding the sewing area, refer to "Temporary
Stop Setting" on page 87.
c
Refer to steps
Begin Changing the Angle at the End of
Sewing by Pressing the "Reverse Stitch"
Button" on page 142 to select the angle
settings for the start and end of sewing.
d
Touch
.
*
If the key appears in light gray, this function cannot
be used with the selected stitch length.
a
a Automatic reinforcement stitching function and
automatic thread cutting function are not
available.
144
a
a
a
d
through
of "Method 1:
e
Start sewing.
The machine stops automatically when sewing is
finished.
f
Peel off the end point sticker.
■ Saving Settings
Specified angles for start and end, finish tapering
method, and stitch settings can be saved in
machine's memory.
a
After setting the tapering function, touch
.
b
Touch
.
■ Retrieving Saved Settings
a
Touch
to retrieve the saved setting
after selecting pattern.
b
Touch the numbered key of the settings to
be retrieved and then touch
*
The settings cannot be retrieved if stitch tapering
function is set to [ON].
Memo
• For more information on saving and recalling
settings, refer to "Saving Your Stitch Settings"
on page 96.
.
Advertisement
Table of Contents
