Appliqué - Brother 882-W33 Operation Manual

Hide thumbs Also See for 882-W33:
Table of Contents

Advertisement

Appliqué
a
Use a temporary spray adhesive, fabric glue
or a basting stitch to attach the appliqué to
the fabric.
*
This will keep the fabric from moving during
sewing.
a Appliqué
b Fabric glue
b
Select
or
.
*
Adjust the stitch length and width to correspond to
the appliqué shape, size, and quality of material.
(page 72)
Memo
• For details on each stitch, refer to "STITCH
SETTING CHART" on page 198.
c
Attach presser foot "J". Check that the
needle drops slightly off the edge of the
appliqué, then start sewing.
a Appliqué material
a Needle drop position
■ Appliqué Sharp Curves
Stop the machine with the needle in the fabric
outside the appliqué. Raise the presser foot and turn
the fabric a little bit at a time while sewing for an
attractive finish to the seam.
■ Appliqué Corners
Stop the machine with the needle in the right
position of the outside (or inside) corner of the
appliqué. Raise the presser foot and pivot the fabric
to align the fabric edge. Lower the presser foot and
continue stitching.
Memo
• Sewing with tear-away stabilizer under the
base fabric will provide the best results.
SEWING THE STITCHES
3
119

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xp3

Table of Contents