Table of Contents
Advertisement
7
Chapter
CARE AND MAINTENANCE
CAUTION
• Be sure to unplug the machine before cleaning
it. Otherwise, injury may result.
Cleaning the LCD
If the surface of the LCD is dirty, lightly wipe it with a soft dry
cloth.
Cleaning the machine surface
When wiping dirt off the machine, firmly wring a soft cloth
soaked in (lukewarm) water.
After cleaning the machine, dry it with a soft, dry cloth.
Restrictions on Oiling
In order to prevent damaging this machine, it must not be
oiled by the user. This machine was manufactured with the
necessary amount of oil applied to ensure correct operation,
making periodic oiling unnecessary.
If problems occur, such as difficulty turning the handwheel or
an unusual noise, immediately stop using the machine, and
contact your authorized Brother dealer or the nearest Brother
authorized service center.
Precautions on Storing the Machine
Do not store the machine in any of the locations described
below, otherwise damage to the machine may result, for
example, rust caused by condensation.
*
Exposed to extremely high temperatures
*
Exposed to extremely low temperatures
*
Exposed to extreme temperature changes
*
Exposed to high humidity or steam
*
Near a flame, heater or air conditioner
*
Outdoors or exposed to direct sunlight
*
Exposed to extremely dusty or oily environments
Note
• In order to extend the life of this machine,
periodically turn it on and use it. Storing this
machine for an extended period of time without
using it may reduce its efficiency.
APPENDIX
CARE AND MAINTENANCE
Cleaning the Race
a
Press
(Needle position button) to raise the needle.
b
Turn the main power to OFF, and then unplug the
machine.
c
Remove the needle and presser foot (page 42,
page 45).
d
Remove the flat bed attachment or the embroidery unit
if either is attached.
e
Insert the multi-purpose screwdriver into the hole, and
tilt the multi-purpose screwdriver to the left and then
to the back, as shown in the illustration.
f
Slide out the needle plate with your right hand to
remove it.
g
Grasp the bobbin case, and then gently lift out.
7
181
Advertisement
Table of Contents
