HP Visualize J2240 Service Handbook page 94

Table 4–8 PROCESSOR DEPENDENT HARDWARE (PDH) (cont.)
Ostat Code Name
WARN 3x04 ERR_WRITING_EEPROM
WARN 3x06 ERR_READING_EEPROM
W WARN N 3 3x1A HVERSION_MISMATCH V S ON_
WARN 3x1B MODEL_STRING_MISMATCH
WARN 3x2A HVERSION_CALC_FAIL
WARN 3xBC WARN_SYSTEM_CLOCKS
FLT 3x00 ROM_XSUM_ERR
FLT 3x01 PDH_CNTRL_ERR
FLT 3x02 SCR_FATAL_ERR
FLT 3x03 SS_FATAL_ERROR
FLT 3x04 FATAL_ERR_WRITNG_EEPROM
FLT 3x05 EEPROM_WRITE_LIMIT
FLT 3x06 FATAL_ERR_READING_EEPROM
FLT 3x08 BAD_SYS_BRD_BYTE
FLT 3x09 BAD_SYS_MODE_BYTE
FLT 3x0A BAD_SYS_MFG_TEST_BYTE
FLT 3x0B PDH_IO_CNTRL_ERR
FLT 3x1B FATAL_MODEL_STRING
FLT 3x1C FATAL_UPDATE_SW_ID
FLT 3xBC BAD_SYSTEM_CLOCKS
FLT 3xCC EARLY_BAD_CACHE_SIZE
FLT 3xCD FATAL_DEFAULTS
FLT 3xF4 EEPROM_BOOT_LIMIT
FLT 3xFC BAD_SYS_BD_ID
FLT 3xFF FAN_FAILURE
x = CPU number
Notes
Error writing to the EEPROM
Error reading EEPROM
S C Stab e Sto e V Stable Store HVERSION didn't match
cacalculated version l l
Model string didn't match caculated vet.
Calculation of HVERSION failed for
CPU x
Skipped system clock test.
EEPROM checksum failed
PDH_IO_CNTRL_REGISTER failure
Fatal error in scratch RAM
Contents invalid and no console
Fatal error writing to the EEPROM
Write limit exceeded
Fatal error reading EEPROM
Invalid SYSTEM_BOARD_BYTE
Invalid SYSTEM_MODE_BYTE
Invalid SYSTEM_MFG_TEST_BYTE
PDH_IO_CONTROL_REG failed
Fatal error while checking model string
Failed SW_ID update
Improper system clock setup
PDH cache size is bad
Fatal error initilaizing stable storage
Number of boots exceeded 95,000 limit
Bad or unknown BD ID (not in J280)
Fan failure detection
S ON d d t atc
d i
Troubleshooting 4–43