Removing The I/O Board - HP Visualize c100 Service Handbook

Field Replaceable Units
FRU Removal and Replacement

Removing the I/O Board

Perform the following steps to remove the I/O board:
1 Pull the ejector handles, as shown in Figure 56.
Figure 56

Removing the I/O Board

2 Slide the board out slowly until it stops, then lift it
straight up.
When replacing the I/O board, line up the t-shaped
standoffs with the large ends of the keyhole slots in the
board, then set the board on the standoffs. Make sure
that the ejector handles are in the fully open position
before sliding the board into place.
148