HP Visualize b132L Upgrade Instructions page 6

Prepare Your Workstation
NOTICE: The bclass_upgrade utility modifies the hardware configuration so that it
is incompatible with a Model B132L or B160L system. After running the
utility, you must continue with this upgrade or restore the configuration
information from /etc/ioconfig.pre_upgrade to /etc/ioconfig and /stand/
ioconfig.
6 Power off your workstation by pressing the power button on the front panel.
If your system has supported graphics adapters installed, continue with step 5, other-
wise skip to step 9
7 When the workstation has completed shutting down and powering off, power it
8 If a message to press Esc to stop the boot process is displayed, then press Esc.
9 Enter the following command to display the console path setting:
4
Enter the following command to run the upgrade utility program:
/usr/sam/lbin/bclass_upgrade
The upgrade utility prompts you to confirm that you want to continue, as fol-
lows:
Are you ready to perform the upgrade (y/n [n])?
Enter Y.
The upgrade utility proceeds to modify the I/O configuration information that is
stored in the files /etc/ioconfig and /stand/ioconfig to be compatible with the
upgraded system. The original I/O configuration information is saved in the
backup file /etc/ioconfig.pre_upgrade.
When you press the power button, the workstation automatically shuts down the
operating system before it powers off the system.
.
back on.
This stops the boot process and brings you to the Boot Console Handler prompt.
pa con
The graphics path for the default console device is displayed. Make note of this
information below for later use.
Console Path: ________________________________________