HP Visualize b132L Upgrade Instructions page 26

Replace the Main Tray Assembly
6 Reconnect the power cables and any other cables that you disconnected when
7 Power on the monitor, the system, and any peripherals.
8 Wait 2 seconds, after the Num Lock light on the keyboard flashes near the end
It takes less than one minute after powering on the workstation
NOTICE:
before the Num Lock light flashes.
9 The system cycles through all of the available monitor types one at a time. When
10 The system queries you to confirm your selection. Press Y to save this monitor
If you have an optional graphics adapter installed, continue with step 12.
Otherwise, wait 15 seconds for the boot sequence to commence, or press any
key other than Tab, and skip to step 18.
24
opening the workstation.
of the boot sequence, for the automatic monitor selection process to start.
Press Tab if the automatic monitor selection process does not start.
you can see a message similar to the following clearly and legibly, select that
monitor type by pressing Enter.
MONITOR INFORMATION
Path Slot
----------- ----
GRAPHICS(0) 0
Press [RETURN] to select this monitor type (type n of n
types).
type.
If you press any key other than Y, the following message is displayed:
Monitor type not saved.
If you didn't press Y, the new monitor type is active, but not saved. Because you
didn't save the monitor type, the next time you reboot the system the original
monitor type will be used.
Next, the following message is displayed:
To select a new Graphics Monitor Type press the <TAB> key
now, otherwise EXIT by entering any other key (or will time
out in 15 seconds)...
To restart the monitor selection process, press TAB.
Head Type Size
---- ---- ----------
1 n nnnnxnnnn
Freq Class
---- -----
nnHz