Replace the Main Tray Assembly
1 Align the main tray assembly with the chassis and slide it into place, as shown in
Figure 16
2 Slide the main tray into the chassis until it is fully seated.
3 Tighten the four thumb screws.
NOTICE:
To maintain regulatory agency compliance, verify that the main tray is
fully seated and all five thumb screws are completely tightened.
4 Replace the system unit in the floor stand.
5 Regardless of whether or not you have a supported graphics adapter, connect
Figure 16.
Replacing the Main Tray Assembly
your monitor's 15-pin connector to the 15-pin connector on the EVC adapter ca-
ble which came with the upgrade kit. Connect the other end of the EVC adapter
cable to the built-in video connector on the rear of the system. Be sure to tighten
the thumbscrews on the connectors.
Replace the Main Tray Assembly
23