Transfer the Optional Fast Wide SCSI Controller from the Old Main Tray to the New Main Tray
Transfer the Optional Fast Wide SCSI Controller from
the Old Main Tray to the New Main Tray
If you have the optional FW SCSI controller, you must remove it from the
old tray assembly and install it on the new tray assembly.
Perform the following procedure to remove and install the FW SCSI control-
ler:
1 Disconnect the end of FW SCSI cable from the FW SCSI controller.
2 Squeeze the three standoffs, as shown in Figure 10, and loosen the FW SCSI con-
Figure 10
Removing the Optional FW SCSI Controller
3 Remove the FW SCSI controller from the connector on the main tray assembly
troller from the standoffs.
as shown in Figure 10.
17