HP Visualize b132L Upgrade Instructions page 24

Replace the Storage Tray
5 Reconnect the floppy, SE SCSI, power, CD-ROM audio, and FW SCSI cables as
6 Reconnect any cables and/or terminators to the SCSI connectors on the rear of the
Storage Tray
Power
Figure 15
22
shown in Figure 15.
When connecting the floppy cable to the system board, use the following proce-
dure:
a Lift the locking ring on the connector to the up, or unlocked, position.
b Hold the cable with the blue stripe on the inside, facing in the direction indi-
cated in Figure 15
c While holding the locking ring in the unlocked position, insert the cable into
the connector with the locking ring.
d Press down on the locking ring evenly on both ends until it snaps into the
down, or locked, position.
chassis.
FWSCSI
SESCSI
CD Audio
Floppy Connector
Connecting the Storage Tray Cables