HP Visualize b132L Upgrade Instructions page 10

Remove the Storage Tray
Remove the Storage Tray
1 Disconnect the cables from the system board and the optional FWSCSI control-
ler, as shown in Figure 3.
When disconnecting the floppy cable use the following procedure:
a Lift the locking ring on the connector to the up, or unlocked position.
b While holding the locking ring in the unlocked position, pull the cable out of
the connector.
2 Disconnect any cables and/or terminators from the SCSI connectors on the rear
of the chassis.
3 Remove the storage tray retaining screw, as shown in Figure 3.
8