Transfer the Optional EGRAM Module from the Old
Main Tray to the New Main Tray
If an optional EGRAM module is installed on the old main tray it must be
transferred to the new main tray.
Remove the optional EGRAM module as follows:
1 Use a pair of needle-nose pliers to squeeze the tabs on the standoffs while lifting
Figure 8
Removing the Optional EGRAM Module
2 Grasp the EGRAM module from the sides and pull it straight up to disconnect it
3 From the bottom of the main tray assembly use a pair of needle-nose pliers to
Transfer the Optional EGRAM Module from the Old Main Tray to the New Main Tray
the corner of the EGRAM module slightly, as shown in Figure 8.
from the main tray assembly connector, as shown in Figure 8.
squeeze the tabs on the standoffs and push them out of the main tray assembly.
15