HP Visualize b132L Upgrade Instructions page 27

11 After choosing and saving your monitor type, the following message is displayed:
To select a new Graphics Monitor Type press the <TAB> key
now, otherwise EXIT by entering any other key (or will time
out in 15 seconds)...
Either wait fifteen seconds for the boot process to continue, or press any key
except TAB.
12 If a message to press Esc to stop the boot process is displayed, then press Esc.
This stops the boot process and brings you to the Boot Console Handler prompt.
13 At the prompt, enter the following command to enter the configuration menu:
co
14 Use the information that you recorded earlier to configure the console path and
monitor type as follows:
mo graphics(n) tt
where graphics(n) is the graphics path that you recorded earlier and tt is the
monitor type that you recorded earlier.
15 Power off the system.
16 Disconnect the EVC adapter cable from the built-in video connector and your
monitor. Then connect the 15-pin connector on your monitor's video cable to the
connector on your graphics adapter
17 Power on the system.
18 After you install a new main tray assembly or I/O board and boot the system for
the first time, you are prompted for the LAN ID. Enter the LAN ID you recorded
in the beginning of this document.
Using the previous example, the address is 080009-70ECC0
19 Pack the old main tray assembly in the packaging from the upgrade kit and use
the documentation provided to return it to Hewlett-Packard.
Replace the Main Tray Assembly
25