Table of Contents
Advertisement
6.2
Power and Control Signal Connector
HR10A-7R-6PB (Hirose) or equivalent
This connector is for the power supply and input / output signals.
The power from this connector is priority power for camera when power supplies through this connector and
PoE at same time.
Please use HR10A-7P-6S (Hirose) or equivalent for cable.
Pin assignment
Pin No.
1
2
3
4
5
6
Configuration of Line2 (Pin No.3) and Line1 (Pin No.4)
Output signal can be assign by GenICam command.
.
1) Frame Trigger Wait (Default for all output)
2) Frame Trigger Internal
3) Exposure Active
4) Acquisition Trigger Wait
5) Acquisition Trigger Internal
6) Sensor Read Out
7) Debounced Line 0
8) Debounced Line 2
9) User Output 1
10) User Output 2
11) Timer 0 Active
12) Software Signal 0
13) Software Signal 1
14) Logic Block 0
15) Pulse Per Second
STC-MBS202POE-BPF
Product Specifications and User's Guide
Signal Name
IN / OUT
POWER IN
IN
Opto-isolated in
IN
(Line0)
Open Collector
IN / OUT
GPIO
(Line2)
Opto-isolated out
OUT
(Line1)
Opto-isolated
IN
Common
GND
IN
GenICam
Voltage
+10.8 to +26.4 Vdc
Low: Smaller than +1.0 V
High: +3.0 to +26.4 V
* Potential difference between
TRG_in and Opt. Isolated Common
+3.0 to +26.4 V / Open Collector
Open Collector
0 V
No.19S195-01
15/65
Advertisement
Table of Contents
