Table of Contents
Advertisement
5.2
Power / IO Control Signal Connector
HR10A-7R-6PB (Hirose)r equivalent
This connector is for the power supply (12Vdc) and input /output signals.
Use HR10A-7P-6S (Hirose) or equivalent for the cable side.
Pin assignment
Pin No.
1
2
3
4
5
6
Configuration of I/O-1(Pin No.2) and I/O-2(Pin No.3)
Output pin can be assigned through register setting or GenICam Command.
STC-SBE132POE / STC-SCE132POE
Product Specifications and User's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
IN /
Signal Name
OUT
GND
IN
I/O-1
OUT
I/O-2
OUT
TRG_In-
IN
(Opt. Isolated -)
TRG_In+
IN
(Opt. Isolated +)
POWER IN
IN
I/O-1 (Pin No.2) / I/O-2 (Pin No.3)
1) FrameTriggerWait (initial setting for I/O-1)
2) UserOutput
3) ExposureActive (initial setting for I/O-2)
4) TriggerAuxiliary
5) TriggerInternal
6) SensorReadOut
7) StrobeSignal
Voltage
0 V
+3.3 V Open Collector
+3.3 V Open Collector
Low: Smaller than +1.0 V
High: +3.0 to +26.4 V
* potential difference between TRG_In-
and TRG_In+
+10.8 to +26.4 Vdc
GenICam command
No.14S002-08
13/53
Advertisement
Table of Contents
