HP P Class 733/800/866MHz / 1GHz Administrator's Manual page 78

4 Installing Other Network Drivers
NDIS 2.01 Driver with Other Networking Products
To install the HP Ethernet Family Adapter NDIS 2.01 DOS or OS/2 driver, follow the
instructions below:
1 Completely install the networking product.
If the product requires that a driver be given and it cannot read the NDIS 2.01
driver off this disk, then pick any other driver to install. In steps 4 and 5 below,
when editing the PROTOCOL.INI and CONFIG.SYS files, change all occurrences
of that driver's name to
2 Create a directory on the computer, for example
commands:
C:
MKDIR C:\NDIS2
3 Copy the NDIS 2.01 driver file from the LAN Disk to this directory.
For DOS computers with the LAN Disk in the flexible drive (for example A) use
the command:
COPY A:\NDIS2\DOS\PCNTND.DOS C:\NDIS2
For OS/2 computers with the LAN Disk in the flexible drive (for example A) use
the command:
COPY A:\NDIS2\OS2\PCNTND.OS2 C:\NDIS2
4 Locate the PROTOCOL.INI file within the networking product's directory created
in step 1 and edit this file with a text editor.
The PROTOCOL.INI file must include a section describing the LAN adapter (that
is, a [PCNTND] section) and a section describing each of the network products
being run. Each network product section must include a BINDINGS statement.
An example section for the HP Ethernet Family Adapter is shown below:
;------------------------------------;
; HP Ethernet Family Adapter ;
;------------------------------------;
DriverName = PCNTND$
BUSTYPE = PCI1
LED2 = 0x90
For a further description of the parameters used by the HP Ethernet Family
Adapter NDIS 2.01 driver, refer to Driver Options - Software Keywords.
78 English
.
PCNTND
, using the following
C:\NDIS2