Other Configuration Problems - HP Net PC 20 Troubleshooting Manual

Other Configuration Problems

Problem Check...
Power-On-Self-Test The Setup
displays an error (one program
that is not covered by an settings.
earlier section in this
chapter).
If the PC still displays an error
This means the configuration settings are
corrupted. Restore the default values.
WARNING: For your safety, never
remove the PC's cover without first
removing the power cord from the power
outlet, and any connection to a
telecommunication network. Always
replace the cover before switching the
PC on again.
CAUTION for NetVectra
N30 NetPCs only:
If system board switches SW5 and SW6
are set to ON and the PC is restarted,
this will initiate the Boot Recovery
option.
1 Turn on or restart the PC.
2 Press Delete or F2 during startup to enter the Setup program.
HP NetPC 20
• Turn off the PC and disconnect the
power cord.
• Remove the cover.
•
To clear the configuration, set the
system board jumper CMOS_CLR to
.
•
To re-enable the configuration, set the
system board jumper CMOS CLR to
.
• Replace the cover, and reconnect the
power cord.
•
Switch on the PC. The PC may start
more slowly than usual because it will
load the default configuration values.
• When the HP Logo appears during
startup, press Delete to enter the
Setup program. Update the necessary
fields, such as the date and time, then
press F10 to save and exit the Setup
program. The PC will restart with the
new configuration.
1 Troubleshooting Your PC
Other Configuration Problems
How
NetVectra N30 NetPC
• Turn off the PC and disconnect the
power cord.
• Remove the cover.
•
To clear the configuration, set the
system board switch SW5 to ON.
• Replace the cover, and reconnect the
power cord.
• Turn on the PC. This will erase the
CMOS memory.
• Turn off the PC, disconnect the power
cord, and remove the cover.
• To re-enable the configuration, set the
system board switch SW5 to OFF.
•
Replace the cover, and reconnect the
power cord.
•
Switch on the PC. The PC may start
more slowly than usual because it will
load the default configuration values.
•
Press F2 during startup to enter the
Setup program. Update the necessary
fields, such as the date and time, then
press F3 to save and exit the Setup
program. The PC will restart with the
new configuration.
English 16