Installing An Optical Drive Into The 5.25-Inch Drive Bay - Compaq dx1000 - Microtower PC Service & Reference Manual

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:
1. Prepare the computer for disassembly
2. Remove the computer access panel
3. Remove the front bezel
4. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove
the bezel blank. See
5. If you are adding a drive to an empty lower optical drive bay, you must remove the knockout plate
from the bay. To do so, insert a flat screwdriver into the knockout plate slot and rotate the
screwdriver to break the knockout plate out of the chassis. Discard the knockout plate.
6. If the new drive has screws installed on the sides of the drive, remove the screws before inserting
the drive into the chassis.
7. Slide the drive in through the front of the chassis (1) until the bezel on the drive is evenly aligned
with the computer front bezel and install the two M3 metric retainer screws (2) as shown in the
illustration below.
NOTE:
M3 metric retainer screws for optical drives are black.
Figure 6-23
8. If the system configuration includes only one optical drive, connect the SATA data cable to the
white system board connector labeled SATA1. If you are adding a second optical drive, connect
the SATA data cable to the orange system board connector labeled SATA3.
(Front Bezel on page
Removing Bezel Blanks on page 36
Extra drive retainer screws are provided on the interior of the front bezel if needed. The
Installing the Optical Drive
(Preparation for Disassembly on page
(Computer Access Panel on page
35).
for more information.
30).
34).
Drives 51