Cross-Connect - ADTRAN SMART/RG SR905ac User Manual

b. If Tagged or DQTagged are selected, the
values are 1 - 4079. The default is 6. Enter the P-bit type. Options are 0 - 7. The default is 0.
c. If DQTagged is selected, the
will be accepted and mapped to the specified WAN. Valid values are 1 - 4062. The default is 0.
3. In the IPV4 Configuration
IPv4 WANs", or "PPPoE for IPv4 WANs".
4. In the IPV6 Configuration
for IPv6 WANs".
5. Click the Apply button in the

Cross-Connect

On this page, you can configure bridge settings for traffic moving from a WAN-side VLAN to a LAN port. This can be used for bridged
IPTV or other services.
1. In the left menu, click
2. Click the Cross-Connect
3. To enable the Cross-Connect feature, click the
4. Configure the tagging options:
a. In the Tag mode
DQTagged. The default is Tagged.
b. If Tagged or DQTagged is selected, the
values are 1 - 4079. The default is 5. Enter the P-bit type. Options are 0 - 7. The default is 0.
SmartRG Inc., an Adtran company. Proprietary and Confidential. All Rights Reserved. © 2020
VLAN
CVID field also appears. Enter the Customer VLAN ID or the first in a range of CVIDs that
section, configure the settings using the information in "DHCP for IPv4 WANs", "Static Address for
section, configure the settings using the information in "DHCPv6 for IPv6 WANs" and "Static Address
Pending changes... dialog box to save your settings.
Network > Ethernet WAN. The Ethernet WAN page appears, showing the
button. The following page appears.
slide button
field, select the type of tagging that should be performed. Options are Untagged, Tagged, and
VLAN
and P-bit fields appear. Enter the ID of the appropriate VLAN. Valid
to the right of Enabled.
and P-bit fields appear. Enter the ID of the appropriate VLAN. Valid
Internet settings.
26