Installing The Edge Power Mount - Garmin EDGE EXPLORE 2 Owner's Manual

Installing the Edge Power Mount

You can use the power mount to install your Edge device and connect it to your eBike. Garmin recommends that
you adjust the mount for the Edge viewing angle before you connect the cable to your eBike.
NOTE: If you do not have this mount, you can skip this task.
1 Select a secure location to mount the Edge device where it does not interfere with the safe operation of your
eBike.
2 Use the 2.5 mm hex key to remove the screw
3 Place a rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
• If the handlebar diameter is 35 mm, do not use a rubber pad.
4 Place the handlebar connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with the grooves on the inside of the handlebar
connector.
46
from the handlebar connector .
Device Information