How To Install Arcs Charts - Furuno FMD-3100 Operator's Manual

3. HOW TO MANAGE CHARTS
3.4.2

How to install ARCS charts

When you install charts from a medium, the system first loads a catalog, which stores
certain information into your SSD such as cell IDs, their position, and edition number,
from the install medium. Then, the system asks which charts you want to install from
the chosen medium. After building the catalog, you can view the contents of it by click-
ing the [Cell Status] button.
Note: Do not cancel the installation (with the [Cancel] button) while it is in progress.
Cancellation automatically resets the power, stopping the installation. If the power is
reset, try to install the charts again. If the installation fails, reset the power and try
again.
1. Set the medium that contains the ARCS charts.
2. Get into the Chart maintenance mode then click the [AUTO Load] button on the
InstantAccess bar. A prompt informs you that it may take a while to do the instal-
lation and are you sure to continue. Click the [OK] button. A message informs you
that the system is searching the medium (in the figure below the medium is a
DVD) for chart data.
The results of the search are displayed, an example of which is shown below. To
cancel the search, click the [Cancel] button.
3. Click the [OK] button to install the charts. The [Install chart data] window appears
and shows the percentage of completion, with digital and analog indications.
3-8