Furuno FMD-3100 Operator's Manual page 18

1. INTRODUCTION
Bottom panel
The bottom panel has connectors and ports for connection of external equipment. The
USB ports, which carry USB 2.0 connectivity, are for connection of the Trackball Con-
trol Unit, USB DVD drive, designated keyboard and printer, mouse and USB flash
memory. Do not connect other equipment to the USB ports.
A USB flash memory must be formatted to FAT32 to use it in the system.
Ground
DC & AC
Terminal
Power Inputs
How to adjust the viewing angle
The viewing angle can be adjusted as shown in the illustration below
Pull and turn the locking pin
clockwise to unlock it.
Note: When unlocking the bracket,
hold the panel PC with both hands
so the panel does not fall down.
Turn the locking pin counter-
clockwise and push it to insert it into
the bracket. If the pin does not insert,
tilt the display forward or backward
slightly until you find the locked
position.
Turn pin counterclockwise
to insert pin in bracket.
1-2
DVI-D Out
RS-232
DVI-I/RGB
RS-485
2x RJ45
Out
Network
Locking pin
(2 pcs., right, left)
Pull; turn
clockwise.
Locking pin
correctly inserted.
USB 1 - 4
No use
2 x IEC 61162-1
2 x IEC 61161-2/1
Tilt the display to desired
angle.
CAUTION
Make sure the locking pins are correctly inserted
into the bracket.
The panel PC may fall if the pins are not correctly
inserted, which may cause bodily injury or damage to
the panel PC.
OK
2 x Removable
Storage Trays
Locking pin not
correctly inserted.