Failure Messages - AGFA D2RS User Manual

4.3. FAILURE MESSAGES

These messages appear at the bottom of touch screen of the
main table control console
They indicate the potential cause of a system failure. In general,
to remove the indication on the console, press OK.
After corrections, if the message persists, turn the system OFF
and ON. Try again movements, if the message remains
displayed or appears often later, turn it OFF and call Field
Service
Messages displayed on bottom of screen
CARRIAGE TIME OUT
COLUMN TIME OUT
TILTING TIME OUT
TABLE HEIGHT TIME OUT
LONG TABLE TOP TIME OUT
S.I.D. TIME OUT
LAT TABLE TOP TIME OUT
TIME OUT COMPRESSOR UP/DOWN
COLLIMATOR FAULT
Collimator Direct Mode(Key is turned)
Sensor ROT. TIME OUT
(for version with removable detector)
DAP METER MISSING
THE GRID DOES NOT FIT THE S.I.D.
REQUIREMENT
GRID INSERTION FAULT
Digital Remote Controlled Table with dynamic flat panel detector
This indicates a system failure with the carriage but allows other movements
This indicates a system failure with the column incidences but allows other
movements
This indicates a system failure with the table tilting but allows other movements
This indicates a system failure with the table variable height but allows other
movements
This indicates a system failure with the tabletop longitudinal movement but
allows other movements
This indicates a system failure with the tube movement (SID) but allows other
movements
This indicates a system failure with the tabletop lateral movement but allows
other movements
This indicates a system failure with the compression device movement but
allows other movements
This indicates a system failure with the collimator shutters movements but
allows other movements
This indicates that the collimator key is turned and selected workstation is
different from direct mode during exposure attempt
This indicates a system failure with the detector rotation but allows other
movements
This indicates a system failure with the Dose Area Product meter system
This indicates an error of use with the grid.
This indicates an error of use with the grid, it is inserted upside down
User's Manual
description
37
What to do
Press OK, move the
system slightly in the
other way and try again
the movement.
If the message appears
again, turn the system
OFF and ON.
If the message appears
whereas switching ON,
then switch OFF and call
Field Service.
If not, try again the
movement, and if the
message appears, turn the
system OFF and call Field
Service
Press OK.
If the message appears
again, turn the system
OFF and ON.
and if the message
appears again, call Field
Service.
Insert the other grid or
continue the procedure
Insert the grid in the right
way