Table of Contents
Advertisement
Installing a blade server
Statement 21:
CAUTION:
Hazardous energy is present when the blade is connected to the power
source. Always replace the blade cover before installing the blade.
Attention:
v Reinstalling a blade server into a different bay from the one from which it was
v If this is the initial installation of a blade server in the BladeCenter HT unit, you
To install a blade server, complete the following steps.
Note: These instructions assume that the BladeCenter HT unit is connected to
power.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Select the bay for the blade server.
removed could have unintended consequences. Some configuration information
and update options are established according to bay number. You might have to
reconfigure the blade server.
must configure the blade server with the blade-server Configuration/Setup Utility
program and install the blade-server operating system. See the documentation
that comes with the blade server for instructions.
on page 31.
Notes:
a. Depending on the blade-server type and the optional devices that are
installed in it, two or more adjacent bays might be required.
Chapter 4. Removing and replacing BladeCenter HT components
61
Advertisement
Table of Contents
