HP Blade Blade Troubleshooting Manual page 72

POST Error Messages
Diagnostic Front Panel LEDs and Audible Codes (Continued)
Activity
Red Power LED
flashes four times,
once every second,
followed by a two
second pause.
Beeps stop after
fifth iteration but
LEDs continue until
problem is solved.
Red Power LED
flashes five times,
once every second,
followed by a two
second pause.
Beeps stop after
fifth iteration but
LEDs continue until
problem is solved.
A–14
Beeps Possible Cause
4 Power failure
(power supply is
overloaded).
5 Pre-video memory
error.
www.hp.com
Recommended Action
1. Open the hood and ensure the 4 or
6-wire power supply cable is
seated into the connector on the
system board.
2. Check if a device is causing the
problem by removing ALL attached
devices (such as hard, diskette, or
optical drives, and expansion
cards). Power on the system. If the
system enters the POST, then power
off and replace one device at a
time and repeat this procedure until
failure occurs. Replace the device
that is causing the failure. Continue
adding devices one at a time to
ensure all devices are functioning
properly.
3. Replace the power supply.
4. Replace the system board.
1. Reseat DIMMs. Power on the
system.
2. Replace DIMMs one at a time to
isolate the faulty module.
3. Replace third-party memory with
HP memory.
4. Replace the system board.
Troubleshooting Guide