Table of Contents
Advertisement
RAPID PRE-HEATING
PROBE (on some models only)
Press and hold the HOME
or the ON-OFF
seconds to stop cooking immediately at
any time and return to the main menu.
Connectivity (on some models only)
Connectivity requirements:
• Smartphone or PC tablet with IOS or
Android operating system. The minimum
versions of the operating systems are
available at the following link:
www.smeg.com/smegconnect/
• Wi-Fi network (2.4 GHz band, WPA2
protected) active and available in the
place where the appliance is installed.
• Internet connection.
• Name and password of the home Wi-Fi
network or WPS (Wi-Fi Protected Setup)
mode available.
For further information, please refer to the
"Built-in oven connectivity" manual.
First use
The following instructions are also valid
in the case of a prolonged power
failure.
To switch on the appliance:
1. Connect the appliance to the mains power
supply.
The manufacturer's logo will display for a few
seconds.
After the appliance is switched on, you
will need to wait a few seconds before
you can use it.
The display then shows the current time setting
screen.
To be able to start any cooking function, the
current time must be set.
91477A327/A
2. Scroll up and down through the hours and
button
button for a few
3. Touch the CONFIRM
The first time you use the appliance, it may be
set to a language other than the one you speak.
It is recommended that you set the required
language at this point.
4. Touch the SETTINGS
5. Touch the display button
6. In the Language
7. Touch the CONFIRM
Deactivating the display
To deactivate the display manually:
• Press and hold the ON-OFF
minutes to set the current time.
right in the lower area
current time.
To change the current time (e.g. due to
daylight saving time) touch the time
shown on the display (in the information
area
on the right).
When the current time is visible, after 2
minutes from the last operation by the
user it is displayed with low brightness.
display (at the right in the lower area
scroll through the available languages (on
the right) to select the required language.
When the "
Show the time" mode is
set to Off, if the time display is shown,
the display will switch off automatically
after 2 minutes.
button for a few seconds until you hear a
button (at the
) to set the
button on the
).
.
option (on the left),
button.
USE - 89
Advertisement
Table of Contents
