Unpacking; Contents Of The Shipping Container - Powermatic 1791216K Operating Instructions And Parts Manual

Unpacking

The band saw is shipped in two cartons. Open
both cartons and inspect contents for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the Band
Saw is assembled and running properly.
Compare the contents of both cartons and all
internal boxes with the following parts list to
make sure all parts are intact.(*) Missing parts, if
any, should be reported to your distributor. Read
this instruction manual thoroughly for assembly,
maintenance and safety instructions.

Contents of the Shipping Container

Carton #1 – Band Saw:
Refer to Figure 9.
1 Band Saw – (A)
1 guide rail – (B)
1 rip fence – (C)
1 rear rail – (D)
1 front rail – (E)
1 trunnion support – (F)
1 level board – (G)
1 miter gauge – (H)
1 main table – (J)
1 extension table – (K)
1 drive belt – (L)
1 quick tension lever – (M)
1 owner's manual (not shown)
1 warranty card (not shown)
2 Hardware packages, as follows.
Hardware Package #1 contains:
Refer to Figure 10.
1 support plate (HP1-A)
1 air jet nozzle (HP1-B)
1 cord clamp (HP1-C)
1 pan head screw, M5x12 (HP1-D)
2 table locking knobs (HP1-E)
6 lock washers, M8 (HP1-F)
8 flat washers, M8 (HP1-G)
5 hex nuts, M8 (HP1-H)
6 hex cap screws, M8x40 (HP1-J)
1 hex cap screw, M8x80 (HP1-K)
Hardware package #2 contains:
Refer to Figure 11.
3 hex (Allen) wrenches, 3,4,5mm (HP2-A)
4 spacers (HP2-B)
4 hex nuts, M8 (HP2-C)
4 socket set screws, M8x20 (HP2-D)
4 socket head cap screws, M6x25 (HP2-E)
4 lock washers, M6 (HP2-F)
4 flat washers, M6 (HP2-G)
4 socket head cap screws, M8x65 (HP2-H)
2 L-spacers (HP2-J)
Figure 9
Band Saw carton
Figure 10
Hardware package #1
(stock no. PWBS14-HP1)
Figure 11
Hardware package #2
(stock no. PWBS14-HP2)
10