Communicating With A Programming Computer; Programming From A Remote Computer Location; Having The Control Panel Call The Remote Computer - Honeywell SILENT KNIGHT SK-5208 Installation And Operation Manual

Model SK-5208 Fire Control/Communicator Installation and Operation Manual
5.8

Communicating with a Programming Computer

An installer at the panel site can initiate communications between the panel and a computer
running the Silent Knight Software Suite SKSS. In order for this communication to function
properly both the computer (running the software) and the control panel must have matching
computer account numbers and computer access codes.
Before you program in this location you should know how your control panel will
communicate with the downloading computer, either through direct connect (RS232) or via
the phone lines (Internal Modem).
5.8.1

Programming From a Remote Computer Location

The panel can communicate with a Up/Downloading computer using two methods. The
control panel can call the programming computer or the programming computer can call the
control panel.
The programming information for the control panel will be stored in the queue of the
downloading software SKSS P/N 5660. This data packet will have been pre-configured for the
control panel that you are about to program. For more information see SKSS Installation
Manual P/N 151240.

5.8.1.1 Having the Control Panel Call the Remote Computer

If the panel initiates the call to a downloading computer, a phone number must be
programmed in the computer accounts area (see Section 4.2.8).
To initiate communication:
4
1. Press the
2. Enter the Installer Code.
The control panel will then begin the communication process with the remote computer.
5-10
up arrow until the display reads Call Computer.
or the
firealarmresources.com
P/N 151204