Electrical Connections - Garland moisture+ MPGD10D Service Manual

ELECTRICAL CONNECTIONS

A separate electrical connection must be supplied for each
oven . Connection to the electrical service must be grounded
in accordance with local codes, or in the absence of local
codes with the National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22 .2, as applicable .
A strain relief for the power supply cord is required . The
installer must supply a cord bushing that meets local and
national codes .
For 120VAC usage a cord and NEMA 5-15P plug is provided .
Garland recommends a separate 15 Amp service for each
oven . Ovens for 120V service are supplied with a three
pronged plug for your protection against shock hazard and
should be plugged directly into a properly grounded three-
prong receptacle .
DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM
THE PLUG.
A wiring diagram is affixed to the rear of the oven and
included in this booklet .
Figure 4 .
Page 12
ELECTRIC OVENS - SHIPPED WITH KNOCKOUT
PLATE FOR POWER SUPPLY
REMOVE THIS SCREW TO ALLOW
ACCESS TO THE TERMINAL BLOCK (ELECTRIC OVENS)
OR CORD CONNECTIONS (GAS OVENS)
CAUTION:
DISCONNECT ALL OVENS FROM ELECTRI-
CAL SUPPLY BEFORE
SERVICING .
POWER FAILURE:
IN THE EVENT OF A POWER
FAILURE, NO ATTEMPT SHOULD BE MADE
TO OPERATE THIS OVEN .
Part # MPSM07 (03/24/08)