To Insert Or Eject A Floppy Disk; To Insert Or Remove A Cd - HP OmniBook 7100 User Manual

1. From the Start menu, shut down the OmniBook. (This is not necessary if you are
removing a battery from the plug-in module bay and inserting another battery).
2. Slide and hold the release latch, then pull out the module, as shown.
3. Slide the new plug-in module into the OmniBook until it clicks into place.
Hint
The battery module fits into either the plug-in module bay or the battery bay. Slide
the front panel of the battery right or left so that it fits into the desired bay.

To insert or eject a floppy disk

When the OmniBook is reading or writing data to the floppy drive,
the floppy disk indicator appears on the status panel.
Caution
Do not insert or remove a floppy disk while the OmniBook is actively reading
or writing data. Wait until the floppy drive is done. Otherwise, you could lose
data or the OmniBook could stop responding.
Hold the disk with its face up, then slide it into the floppy drive slot (on the front
of the OmniBook) until it clicks into place.
To remove the floppy disk, press the eject button next to the slot.

To insert or remove a CD

When the OmniBook is reading data from the CD-ROM drive, the
CD-ROM/hard disk drives indicator appears on the status panel.
Caution
Do not insert or remove a CD while the OmniBook is actively reading data.
Wait until the CD-ROM drive is done. Otherwise, the OmniBook could stop
responding.
29