To Remove A Pc Card - HP OmniBook 7100 User Manual

Do not install Card Services or Socket Services software if it comes with your
PC Card.
Windows 95 already includes Card Services and Socket Services, which
automatically detect and set up PC Cards you install in the upper and lower card
slots. Different versions of this software will disrupt this support.
Windows NT 4.0 requires that you install Phoenix Card Executive drivers. See the
OmniBook Reference Guide for instructions.
The OmniBook automatically detects and sets up a card when you insert it in a card
slot. See the card's instructions for additional information.
1. Hold the card with its face up with its connector holes toward the card slot.
2. Slide the card into a PC Card slot until it won't go any further. A double beep
signals that the card has been recognized and is successfully configured by your
computer.

To remove a PC Card

Caution
Never remove an I/O card while an application is open that's set up to use that
card. If you remove the card, the application (or the OmniBook) might behave
unpredictably or stop responding until you reset the OmniBook. Exit the
application first.
Never insert or remove a plug-in card while the PC Card drive is actively
reading or writing data. Check the PC Card indicator in the
wait until the PC Card drive is done. Otherwise, you could lose data or the
OmniBook could stop responding.
1. Stop the PC Card by clicking the PC Card indicator in the taskbar, then clicking
Stop.
This protects your data and avoids unexpected problems. You can restart the
card by removing it, then inserting again.
2. Press the ejector button once to pop the button out.
3. Press the ejector button again to pop the card out.
status panel and
36