To Add Memory To The Omnibook - HP OmniBook 5700 Installation And Setup Manual

To add memory to the OmniBook

The OmniBook memory slots accommodate two memory-expansion boards. You
can install a memory-expansion board to increase the total amount of memory.
C A U T I O N Take precautions against damage from static electricity: Gather all the parts
you need so you can complete the installation in one sitting. Don't remove the
memory -expansion board from its packaging until you've removed the slot
cover from the OmniBook. Do not use an ac adapter from another product.
When you remove the board from its packaging, hold it only by its edges. Don't
touch the electronic components or gold traces. Also, turn off the unit, unplug
the ac adapter, and remove the battery. Otherwise, the OmniBook or
memory -expansion board may be damaged.
1. Exit Windows—your current session and any data not saved will be lost.
2. Unplug the adapter and remove all batteries from the OmniBook.
3. Use a flat-blade screwdriver to remove the cover from the expansion slot.
4. If a memory-expansion board is already present in both slots, pull out the board
5. Position the memory-expansion board over the connectors and press in the
6. Replace the slot cover.
7. Insert the battery, then press the blue On/Suspend button.
8. When you see the following message:
9. Press ALT+X to open the SCU Exit menu.
10. Click Save and Exit to update the system configuration.
If you're using Windows 95, use the shutdown option from the Start menu.
If you're using Windows for Workgroups, exit Windows, then press
the square Off button.
you want to replace. Use the tape tab to loosen the card from its connectors,
then lift.
board until it seats fully. Be careful not to press in the center of the board as this
could crack it.
WARNING - UNEXPECTED AMOUNT OF MEMORY - RUN SCU
press F2 to go to the System Configuration Utility.
Expanding the OmniBook
Replacing Hardware
3-5