Power Connector - HP G62-373 Maintenance And Service Manual

Removal and replacement procedures

Power connector

Description
Power connector (includes cable)
Before removing the power connector cable:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first disconnecting the power cord from the AC outlet and then
disconnecting the AC adapter from the computer.
4. Remove the battery (see
5. Remove the battery (see
6. Remove the battery (see
7. Remove the hard drive (see
8. Remove the memory module (see
9. Remove the wireless module (see
10. Remove the optical drive (see
11. Remove the keyboard (see
12. Remove the top cover (see
13. Remove the display assembly (see
Remove the power connector cable:
1. To remove the power connector cable, disconnect the cable connector 1 from the system board.
2. Remove the power connector cable by lifting it straight up from the base enclosure 2.
Reverse this procedure to install the power connector cable.
4–34
"Battery" on page 4-7)
"Battery" on page 4-7).
"Battery" on page 4-7).
"Hard drive" on page
"Memory module" on page
"Wireless module" on page
"Optical drive" on page
"Keyboard" on page 4-17).
"Top cover" on page
"Display assembly" on page
4-8).
4-10).
4-12).
4-14).
4-20).
4-26).
Spare part number
602743-001
Maintenance and Service Guide