Vlan Configuration - ZyXEL Communications XS1930-12F User Manual

Figure 92 Advanced Application > VLAN > VLAN Detail
The following table describes the labels in this screen.
Table 51 Advanced Application > VLAN > VLAN Detail
LABEL
VLAN Status
VID
Port Number
Elapsed Time
Status

9.4 VLAN Configuration

Use this screen to view IEEE 802.1Q VLAN parameters for the Switch. Click Advanced Application > VLAN
> VLAN Configuration to see the following screen.
Figure 93 Advanced Application > VLAN > VLAN Configuration
The following table describes the labels in the above screen.
Table 52 Advanced Application > VLAN > VLAN Configuration
LABEL
Static VLAN Setup
VLAN Port Setup
Voice VLAN Setup
Vendor ID Based VLAN Setup
Chapter 9 VLAN
DESCRIPTION
Click this to go to the VLAN Status screen.
This is the VLAN identification number that was configured in the corresponding VLAN
configuration screen.
This column displays the ports that are participating in a VLAN. A tagged port is marked as T, an
untagged port is marked as U and ports not participating in a VLAN are marked as "–".
This field shows how long it has been since a normal VLAN was registered or a static VLAN was
set up.
This field shows how this VLAN was added to the Switch.
• Dynamic: using GVRP
• Static: added as a permanent entry
DESCRIPTION
Click Click Here to configure the Static VLAN for the Switch.
Click Click Here to configure the VLAN Port for the Switch.
Click Click Here to configure the Voice VLAN for the Switch.
Click Click Here to configure the Vendor ID Based VLAN for the Switch.
XS1930 Series User's Guide
124