ZyXEL Communications XS1930-12F User Manual page 184

The following table describes the labels in this screen.
Table 83 Advanced Application > Classifier > Classifier Configuration
LABEL DESCRIPTION
Active Select this option to enable this rule.
Name Enter a descriptive name for this rule for identifying purposes.
Weight Enter a number between 0 and 65535 to specify the rule's weight. When the match order is in manual
mode in the Classifier Global Setting screen, a higher weight means a higher priority.
Log Select this option to have the Switch create a log message when the rule is applied and record the
number of matched packets in a particular time interval.
Note: Make sure you also enable logging in the Classifier Global Setting screen.
Count Select this option to have the Switch count how many times the rule is applied.
Time Select the name of the pre-configured schedule that you want to apply to the rule. The rule will be
Range active only at the scheduled date and/or time.
If you select None, the rule will be active all the time.
Ingress Port
Port Type the port number to which the rule should be applied. You may choose one port only or all ports
(Any).
Trunk Select Any to apply the rule to all trunk groups.
To specify a trunk group, select the second choice and type a trunk group ID.
Layer 2
Specify the fields below to configure a layer 2 classifier.
VLAN
VLAN Select Any to classify traffic from any VLAN or select the second option and specify the source VLAN
ID in the field provided.
Priority
Priority Select Any to classify traffic from any priority level or select the second option and specify a priority
level in the field provided.
Ethernet Select an Ethernet type or select Other and enter the Ethernet type number in hexadecimal value.
Type
Source
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a source, select MAC/Mask to enter the source MAC address of the packet in valid MAC
address format (six hexadecimal character pairs) and type the mask for the specified MAC address to
determine which bits a packet's MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should match. Enter
"0" for the bits of the matched traffic's MAC address, which can be of any hexadecimal characters.
For example, if you set the MAC address to 00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet
with a MAC address of 00:13:49:12:34:56 matches this criteria. If you leave the Mask field blank, the
Switch automatically sets the mask to ff:ff:ff:ff:ff:ff.
Destination
Chapter 21 Classifier
XS1930 Series User's Guide
184