ZyXEL Communications XS1930-12F User Manual page 81

Figure 57 Status > Neighbor
The following table describes the fields in the above screen.
Table 22 Status > Neighbor
LABEL DESCRIPTION
Port This shows the port of the Switch, on which the neighboring device is discovered.
Port Name This shows the port description of the Switch.
Link This shows the speed (either 100M for 100 Mbps, 1G for 1 Gbps, 2.5G for 2.5 Gbps, 5G for 5
Gbps, or 10G for 10 Gbps) and the duplex (F for full duplex or H for half). This field displays
Down if the port is not connected to any device.
PoE Draw (W) This shows the consumption that the neighboring device connected to this port draws from
the Switch. This allows you to plan and use within the power budget of the Switch.
System Name This shows the system name of the neighbor device.
IPv4 This shows the IPv4 address of the neighbor device. The IPv4 address is a hyper link that you
can click to log into and manage the neighbor device through its Web Configurator.
IPv6 This shows the IPv6 address of the neighbor device. The IPv6 address is a hyper link that you
can click to log into and manage the neighbor device through its Web Configurator.
PWR Cycle Click the Cycle button to turn OFF the power of the neighbor device and turn it back ON
again. A count down button (from 5 to 0) starts.
Note: The Switch must support power sourcing (PSE) or the network device is a
Reset to Default Click the Reset button to reset the neighboring device to its factory default settings. A
warning message "Are you sure you want to load factory default?" appears prompting you
to confirm the action. After confirming the action a count down button (from 5 to 0) starts.
Note:
•
•
•
Select an entry's check box to select a specific port. Otherwise, select the check box in the
table heading row to select all ports.
Flush Click the Flush button to remove information about neighbors learned on the selected
ports.
Chapter 7 Status
powered device (PD).
The Switch must support power sourcing (PSE) or the network device is a powered
device (PD).
If multiple neighbor devices use the same port, the Reset button is not available.
You can only reset Zyxel powered devices that support the ZON utility.
XS1930 Series User's Guide
81